These are most commonly known as pneumatic gravity conveyors and used for transporting/feeding fine & pulverized material. It consist of two compartments separated by porous fabric. Bottom compartment is supplied with air and upper compartment carries material. The inclination and air pressure moves the material in forward direction. The inclination is usually between 6 to 8 degrees to the horizontal. We have standardized design for aero-slide ranging from 150 mm to 865 mm wide for various length for maximum conveying capacity upto 1400 Cu. Meter/hour.

This equipment is motor operated and used for infinite quantity controlling the rate of material flow in the range of 0-100%. We manufacture flow control gate ranging from 200 mm to 650 mm size depending upon the volumetric capacities. The housing and rotor can be offered for both options, casting & fabricated design. Special FELT material is used for sealing to ensure dust tight operation.
The motorized actuators are sourced from M/s. AUMA India Ltd. These are complete with inbuilt torque switches & limit switches.
Dial type continuous mechanical indicator is provided as standard feature of the equipment. Optionally potentiometer with transmitter can be provided for remote indication of gate position.

We make manual shut off aeroslide gates of sizes varying from 200mm to 1200mm. They are used in extraction systems for taking the pneumatic gates as well as dozing valves into servicing. They can be made low friction by using rollers instead of pins based on the application. For the flap Sail Hard or Stainless steel can be used as per the customers' requirement.

Click Here for technical details

This equipment is used for ON/OFF purpose of material flow.
Construction features are same as flow control gate but on / off operation is through pneumatic cylinder. Design is available from 200 mm to 650 mm size depending upon volumetric capacities. Due to rotary type of construction sealing efficiency is much better than slide type shut off gate.

A Splitter is used for dividing the flow of material between 20 - 80% of the maximum flow rate. Motorized Splitters are installed as a part of aero-slide system. This is a specially designed equipment to split the Raw meal in desired proportioning quantity for feeding into two
different pre-heater streams. The operational control of the actuator is done from control room by sensing the pre-heater string temperature and thereby proportionately adjusting the splitter gate position.

This equipment is used for discharging material at one side of the conveyor anywhere in line of the conveying system. These are very useful specially for feeding various numbers of silo system in systematic manner as desired.
We design and manufacture side discharger for various materials for various capacities with motorized or pneumatic mode of operation suitable for all the aero-slide widths.

This equipment is used when material is to be conveyed straight or to be discharged underneath the conveying system. It consists of a movable aerated bottom, which is used for discharging material.
We design and manufacture bottom discharger for various materials for various capacities with motorized or pneumatic mode of operation suitable for all standard aero-slide widths.

Nib Trap arrangement consists of Aerated Conical Chamber design gate with deep material chamber. This is installed in between the aero slides. Separate high pressure Roots Blower is used for aeration of Nib Trap. Fine material (Cement/Ground Slag) will be conveyed through aero slides & the Nibs shall get collected in the Nib trap. Two Nos. manual Slide Gates are provided below the Nib trap for removal of Nibs as & when required.